Cuboid 200 Atomizer Short

Discussion in 'Archive' started by ilyxa, Jul 21, 2017.

Thread Status:
Not open for further replies.
  1. ilyxa

    ilyxa New Member

    Joined:
    May 16, 2017
    Messages:
    8
    Likes Received:
    1
    Cuboid 200 h/w 1.02, AF 170716, 170624
    Steps to reproduce.
    One:
    - remove atomizer
    - press fire button
    - got "Atomizer short" message

    Two:
    - remove atomizer
    - install Joeytech USB
    - start Powerbank mode
    - press fire button
    - got atomizer short

    Expected behaivior: working Powerbank mode, message "No atomizer found" if no atomizer installed.
     
    #1 ilyxa, Jul 21, 2017
    Last edited: Jul 23, 2017
  2. Outerrim

    Outerrim New Member

    Joined:
    Jul 22, 2017
    Messages:
    8
    Likes Received:
    2
    I have the same behavior on Cuboid with the Firmware 170716, 170624,170603
     
    ilyxa likes this.
  3. maelstrom2001

    maelstrom2001 Developer
    NFE Team

    Joined:
    May 4, 2017
    Messages:
    1,237
    Likes Received:
    1,120
    Suddenly.
    Is that Cuboid 200 for sure, or 150? Because hardware version seems too high for 3-cells Cuboid 200.
    @Outerrim which hardware version has your Cuboid?
    The last known HW version of Cuboid is 1.02.

    The second question: can you point to build which has no this issue? Or it was always, but I'm reading about this just now?
     
  4. Outerrim

    Outerrim New Member

    Joined:
    Jul 22, 2017
    Messages:
    8
    Likes Received:
    2
    I have a Cuboid 150,but with firmware update vom Joytech 200W.Hardware version is 1.01
     
  5. ilyxa

    ilyxa New Member

    Joined:
    May 16, 2017
    Messages:
    8
    Likes Received:
    1

    1st. 1.02, of course. My mistake. Cuboid 200.
    2nd. to be honest - never try to fire it w/o atom or jmay be just ignored this error (if intermittent button press happened), problem was raised when i try to use it as power bank (of course, USB connector checked on another device, Pico 75 with latest dev-build, there is no mechanical problem on it).
     
  6. ReikoKitsune

    ReikoKitsune Developer
    NFE Team

    Joined:
    May 4, 2017
    Messages:
    674
    Likes Received:
    564
    Just tested my old Cuboid 150W(200) and here are results:
    • 170603 - no atomizer found.
    • 170610 - no atomizer found.
    • 170624 - no atomizer found.
    • 170716 - no atomizer found.
    I guess in your case problem with 510 connector.
     
    ilyxa and maelstrom2001 like this.
  7. ilyxa

    ilyxa New Member

    Joined:
    May 16, 2017
    Messages:
    8
    Likes Received:
    1
    timeout for few more hours ;)
     
  8. ilyxa

    ilyxa New Member

    Joined:
    May 16, 2017
    Messages:
    8
    Likes Received:
    1
    new thing. Battery low in powerbank mode... After few try Powerbank activated, but device going extra hot VERY fast.
     
  9. maelstrom2001

    maelstrom2001 Developer
    NFE Team

    Joined:
    May 4, 2017
    Messages:
    1,237
    Likes Received:
    1,120
  10. ilyxa

    ilyxa New Member

    Joined:
    May 16, 2017
    Messages:
    8
    Likes Received:
    1
    Good news! Testing few hours af_170720 - everything looks good now (no sporadic "low battery", "overload", other confusing messages, no reboots while trying to start powerbank mode).
     
Thread Status:
Not open for further replies.