Longer Preheat

Discussion in 'Suggestions' started by B__cuL, Aug 11, 2019.

  1. B__cuL

    B__cuL New Member

    Joined:
    Aug 11, 2019
    Messages:
    2
    Likes Received:
    0
    Hi,
    would that be possible to allow longer preheat. Currlently it is limited to 2s.
    Longer preheat would be useful for users that vapour with dry medicament heaters, like RBT Splinter. 25-35W is what it needs normally, but at the beginning it is good to threat it with 40W for about 4-5 seconds.
     
  2. slavyk

    slavyk New Member

    Joined:
    May 17, 2017
    Messages:
    20
    Likes Received:
    10
    You can use curves!
     
    maelstrom2001 likes this.
  3. B__cuL

    B__cuL New Member

    Joined:
    Aug 11, 2019
    Messages:
    2
    Likes Received:
    0
    Thanks for the hint.

    The point is that the curves are based on % of the main W value. And my main power value increases with every vaporisation. This is because the dry medicament becomes even more dry after each shot.
    It looks like that more or less:
    1st: 40W preheat (5s) .... then 25W,
    2nd: 40W preheat (5s) .... then 30W,
    3rd: 40W preheat (5s) then 35W,
    and so on.
    So in order to keep my max preheat value at 40W level I'd need to have curves defined in Watts not in %s.

    I was thinking about the preheat to make it as straight forward as possible, with "zero" learning curve. Just change the preheat value to 5s and that's it.

    I belive that this wouln't be a huge change in the firmware.
     
    #3 B__cuL, Aug 12, 2019
    Last edited: Aug 12, 2019