Separate names with a comma.
Discussion in 'Suggestions' started by Surfparadise, Jun 15, 2018.
Yes, download and flash it as described in this post.
No, use only NFE Tools v190718 from this link.
I tried two different PCs but my rsq does not get detected, even using Zadig and trying all driver types, any suggestion to make it work ?
День добрый, подскажите, пожалуйста, показывает ли ваша прошивка Свага сопротивление онлайн, так сказать? Как Арктикфокс на Пико 75
Добрый день. Да, это полноценный ArcticFox. За исключением Logo, разве что - в ветке STM32 его нет и не будет.
Спасибо, но все равно не получается. Демо не видит мой мод, хотя он коннектится с компом
Зажмите Fire + Menu и посмотрите версию hardware. Если это SPCBAT, то шансов нет
Hello and thanks for the great software!
I use it on Pico 25 without problems.
But now, on Swag 1gen, I followed the steps explained here but DfuSe Demo doesn't recognize the Swag.
(The hardware version is 1.03; TPCBATG-2; 01.24.2018)
Do I need to download additional drivers and all the archives under the post with the steps?
I would appreciate your help
You have to install DfuSe Demo, and it contains driver.
Check Windows Device Manager, in the section "Universal Serial Bus controllers" should be "STM Device in DFU Mode". If no, probably there are problems with USB stuff (cables, connectors, ports etc.).
Just out of curiosity, did anyone check if the Reverent Delta board can be booted in DFU mode?
Hello to all, first thank you very much for your work !
I have a 1st version SWAG, firmware OK.
When I plug it into my computer, it's installed as "DFU in FS mode" and not detected by DFUSE demo.
It seems the wrong drivers are installed as it's not detected as "STM32 device in DFU mode"
Where can I find the good drivers ? (I have a very old laptop under win XP)
Thank you for your help !
As far as I was able to find out there are only Vista drivers there (!discontinued! Link). For XP I couldn't find any.
Thanks for your help anyway
Try DfuSeDemo 3.0.5: http://wiki.amperka.ru/_media/js:ide:dfu-firmware:en.stsw-stm32080.zip (uninstall 3.0.6 first).
Also try to update drivers itself:
Thank you very much Maelstrom2001.
I'll try this as soon as possible and will report !
You all do a great job here, congratulations