Wismec Reuleaux Gen3 not recognised

Discussion in 'Issues' started by bac0n, Dec 9, 2017.

  1. bac0n

    bac0n New Member

    Joined:
    Dec 9, 2017
    Messages:
    2
    Likes Received:
    1
    I installed AF version: 171126
    I'm using NFE Tools Version: 171128
    I JUST installed the Firmware about an hour and thirty min ago.
    I was attempting to connect my Gen3 to set a logo.
    I am using the USB cord supplied with the device(first time ever using it) and it worked fine to update to Arctic Fox, but now will not recognize that the mod is connected. the wismec software no longer recognizes it either. attached is a Screen Capture of the error i am getting. I only have one computer, so attempting on a different one is out. i have checked 4 other cables provided from other mods i have purchased, and all of them result in the same outcome. HELP!
     

    Attached Files:

  2. bayu099

    bayu099 New Member

    Joined:
    Sep 17, 2017
    Messages:
    22
    Likes Received:
    1
    Try to connect it without battery, and then unplug usb cable from your mod , insert battery and reconnect again

    Sent from my ASUS_Z008 using Tapatalk
     
  3. bac0n

    bac0n New Member

    Joined:
    Dec 9, 2017
    Messages:
    2
    Likes Received:
    1
    I’m at work. I’ll try when I get home at 6. I hope it works.
     
    bayu099 likes this.
  4. Frans

    Frans New Member

    Joined:
    Apr 21, 2018
    Messages:
    1
    Likes Received:
    0
    Maybe late: First upload with older NFE tool, newest firmware, then use newest NFE tool. It will work.
     
  5. kmnvandrey

    kmnvandrey New Member

    Joined:
    May 13, 2018
    Messages:
    1
    Likes Received:
    0
    Подскажите, пожалуйста, почему NFE Tools не видит мод?
    Инструменты NFE-v190703-21.46
    Прошивка - af_190624
    Мод - Wismec Reuleaux RX Gen3
    Заранее спасибо!
     

    Attached Files: